Audioheader

Mocat-1 (microphone over cat 5)

The highly successful MOCAT-1 has been designed to simplify and speed up installations where multiple microphone inputs or line level inputs need to be situated a distance from the amplifier equipment.
Types of installation include churches, schools, theatres and corporate boardrooms.

MOCAT-1 is an extremely versatile and cost effective installation device that removes the need for multiple cable runs from remote audio inputs to the amplifier equipment.
The MOCAT-1 can transmit up to four microphone or line level signals down one screened cat5e cable for up to 1000 metres. This is reduced to 3 channels if using unscreened cat5e cable.

Each input and output can be independently configured for balanced or unbalanced signals as well as line level or microphone level.
There is also an option to provide phantom power to the microphone inputs independently.
Each unit fits neatly into a standard UK double back box and only requires a power supply at the output or amplifier end (PSU supplied as part of system).

mocat

Features:
Reduces installation time
Up to 1000M between Input and Output plates
Very high interference immunity
Balanced or unbalanced inputs & outputs
Line or Microphone level inputs & outputs
Phantom powering (max.15V DC)
Four XLR sockets on standard 2 gang plate
Black or White face plates available
No power required at input module

Specification:
Input Module:
Power Over cat5 cable
Ground Over cat5 cable screen (or spare pair)
Inputs x 4 Balanced XLR female
MIC / LINE in Selectable by jumper
Phantom power 15v jumper selectable
MIC impedance 600R
MIC input level 10mV RMS
LINE impedance 50K
LINE input level 700mV RMS (1.5v RMS max)

Output Module:
Power requirements 24VDC @ 100mA (regulated linear power supply recommended)
Outputs x 4 Balanced XLR male
MIC / LINE out Selectable by jumper
MIC out impedance 600R
MIC level output 20mV RMS (into 600R)
LINE out impedance 20K
LINE level output 700mV RMS (into 20k)

General:
Four individually configurable channels
Bandwidth 100Hz to 20Khz (-3dB)
Crosstalk >60dB
Signal to Noise Ratio >60dB
Cable spec SCREENED cat5e cable (can use UTP but one pair required for ground meaning only three channels would be available)
Cable length 1000 Metres maximum
Cat5 terminations Screw terminals
Protected against short circuit on CAT5 cable to ground.

Click here for BROCHURE

Click here for SUPPORT

Please Note:
When using Cat5UTP (unshielded cable, the Mocat system is only capable of transferring up to 3 Channels.
STP(shielded) Cat5 cable will allow for the maximum 4 channels.